A drain that keeps blocking almost always has a cause that clearing alone doesn’t fix. Wet wipes and grease build up again, roots grow back through cracked joints, and damaged, sagging or badly laid pipes keep catching waste. Rodding or jetting restores the flow for a while, but the blockage returns until someone finds and fixes the underlying defect, usually with a CCTV drain survey.
Repeat blockages cost more than a one-off call-out. Each one risks sewage backing up into your home, and some causes, such as a cracked or collapsing pipe, get worse every time they block. This guide walks through the ten most common causes, how to read the symptoms and what actually stops the cycle.
10 Common Causes of Repeated Drain Blockages
1. Wet wipes and sanitary products
Wipes, sanitary towels and cotton buds don’t break down like toilet paper. They snag on any rough joint and build into a plug. If someone in the house keeps flushing them, the drain will keep blocking, however often you clear it. The government has banned wet wipes containing plastic in England from 19 May 2027, but plastic-free wipes still belong in the bin.
2. Fats, oils and grease
FOG (fats, oils and grease) runs down the sink as a liquid, then cools and coats the pipe. Each layer narrows the pipe a little more, so a kitchen drain often slows gradually before it blocks. Rodding punches a hole through the grease and leaves the rest on the walls, which is why grease blockages come back quickly.
3. Tree roots
Roots find their way into cracks and joints in search of water and nutrients. Once inside, they spread into a net that catches waste. In Poole, a CCTV survey showed roots growing through defective joints in clay pipes and causing repeated blockages. Our engineers cut the roots out, jetted the pipe clean and relined it to seal the joints.
4. Cracked clay pipes and displaced joints
Many older homes still drain through clay pipes laid in short lengths. Over decades, ground movement, traffic and roots crack the pipes and push joints out of line. A displaced joint leaves a lip that catches paper and wipes every time someone flushes. Our guide to what a CCTV drain survey can detect shows how these defects look on camera.
5. Collapsed sections
A partly collapsed pipe narrows the flow and lets soil fall in. Blockages at a collapse tend to come back fast and get worse each time. At a block of flats in Bournemouth, a collapsed interceptor junction left the chamber full of compacted waste. Jetting couldn’t clear it, so our team used a vacuum tanker to empty the chamber and expose the failed pipework for repair.
6. Limescale
In hard water areas, calcium deposits build up inside pipes, especially in drains that take hot water from washing machines and dishwashers. Scale roughens the pipe wall and narrows it, so debris catches more easily. On one limescale job, a property had suffered repeated blockages and poor flow until we removed heavy scale from the pipework and restored its full diameter.
7. Incorrectly installed pipework
Pipes need a steady fall to carry solids away. A run laid too flat, with a back-fall or with sharp bends lets solids settle and block. Other installation faults include branch connections made without proper fittings and pipes that change size in the wrong direction. These faults never fix themselves, so the blockages repeat until someone relays the pipe.
8. Sagging pipes
Even a well-laid pipe can sink if the ground beneath it settles or washes away. Water then sits in the dip, and solids drop out of the flow. The camera shows a section of standing water in a pipe that should run dry.
9. Interceptor traps
Many older homes have an interceptor trap in the last chamber before the public sewer. Its U-shaped bend catches solids, and its rodding arm has a stopper that can fall into the trap and block it. Interceptor traps block more often than a straight pipe and sometimes need replacing with a standard channel.
10. Pitch fibre deformation
Pitch fibre pipes, laid widely in the decades after the Second World War, soften and flatten with age. As the pipe loses its round shape, the gap narrows and blockages become more frequent. Our guide to pitch fibre drains covers the repair options.
How Symptoms Differ by Cause
The way a drain blocks often hints at the cause. A kitchen sink that slows gradually over several weeks usually points to grease and food. A toilet that blocks soon after heavy use suggests wipes, sanitary items or a displaced joint that catches them. Blockages that get worse in late summer and autumn often mean roots, which grow fastest then.
Other clues come out during clearance. If the rods bring up soil, stones or grit, the pipe has probably cracked or collapsed. A drain that blocks at the same chamber every time usually has an interceptor trap, a poor connection or a defect just downstream. Water that still stands in a chamber after clearing suggests a sag or back-fall, and slow drains across a hard water area often come down to limescale. A camera survey confirms which one you’re dealing with.
Why Clearing a Drain Again Doesn’t Fix It
Rodding and jetting remove what’s blocking the pipe today. They don’t seal a crack, lift a sagging pipe or straighten a displaced joint. If the defect stays, the next lot of waste catches in the same place.
Each repeat blockage also leaves its own evidence. A drain that blocks at the same chamber every time points to a fixed defect nearby, while one that blocks in different places points to something going down the drain, such as grease or wipes.
Repeated clearing can also make some faults worse. Rods pushed hard through a fractured clay pipe can knock loose pieces into the flow, and roots cut back without sealing the joint grow back thicker.
Blocked again? Call NOW Drainage on 0800 001 6568. We clear the blockage and, where it keeps coming back, find out why.
When Should You Get a CCTV Inspection?
We recommend a CCTV drain survey as soon as the same drain blocks a second time within a few months. The same applies when an engineer finds soil, stones or roots while clearing, or when water still stands in a chamber after the blockage has gone. A survey also settles arguments: when several properties share the problem, it shows whose pipe has failed, and it gives insurers, landlords and buyers the evidence they ask for.
The survey shows the exact defect and its position, so the repair targets the right spot. In Talbot Woods, Bournemouth, a CCTV inspection after repeated blockages showed a damaged, unreliable clay drain run. That evidence shaped the whole repair.
How Professional Repairs Fix the Underlying Defect
The right repair depends on what the camera finds. Where grease, scale or silt caused the blockages, high-pressure jetting scours the pipe walls and restores the full bore. Our guide to high-pressure drain jetting explains how it works. Jetting alone fixes the problem only when build-up was the whole story.
Cracks, open joints and root ingress call for structural relining. The engineer installs a new pipe inside the old one, sealing the defects without digging, which stops roots getting back in and gives waste a smooth path. In Poole, our team used a cured-in-place liner to seal the joints after removing the roots.
When a pipe has collapsed or sits at the wrong gradient, lining it won’t help, so the engineer digs it up and replaces it. In Talbot Woods, our team excavated the damaged clay sections, replaced them with PVC pipework and new access points, relined one section from inside to protect the patio, and then reinstated the patio.
Our guide to drain relining vs excavation compares the two methods in detail.
How to Stop Your Drain Blocking Again
Prevention starts with what goes down the drain. These habits make the biggest difference:
- Bin wipes, sanitary products and cotton buds. Only the 3 Ps (pee, poo and paper) belong in the toilet.
- Scrape pans before washing them. Let fat cool, scrape it into the bin and use a sink strainer.
- Keep gullies clear. Lift leaves and silt out of outside gullies in autumn.
- Act on early signs. Gurgling, slow drains and smells usually come before a full blockage.
Think about the bigger picture too. Plant new trees well away from drain runs, and if a drain has a history of grease or scale, book routine maintenance jetting before it blocks rather than after.
Frequently Asked Questions
Why does my drain keep blocking?
Most recurring blockages come from a cause that clearing doesn’t remove: wipes or grease going down the drain, roots in the joints, a cracked or displaced clay pipe, a collapse, limescale, or a pipe laid or sunk at the wrong gradient. A CCTV survey identifies which one applies.
How often is too often for a drain to block?
A healthy drain shouldn’t block at all with normal use. If the same drain blocks twice within a few months, book a CCTV survey rather than another clearance.
Can jetting stop a drain blocking again?
Jetting removes grease, scale and silt and can solve the problem if build-up caused it. It can’t repair cracks, displaced joints or sagging pipes, so blockages caused by those defects will return.
Will relining stop roots coming back?
Relining seals the cracks and joints that roots use to get in, so it stops roots re-entering the lined section. Removing the roots without sealing the pipe usually leads to regrowth.
Is a recurring blockage my responsibility or the water company’s?
It depends on where the blockage sits. You usually own pipes inside your boundary that serve only your home, while water companies look after most shared sewers and lateral drains. Our guide to who is responsible for a blocked drain explains the rules.
Can a drain that keeps blocking damage my home?
Yes. Each blockage can push sewage back up into toilets, showers and gullies, and a cracked pipe that stays blocked leaks wastewater into the ground around it. Over time that leakage can wash soil away from foundations and paving, so recurring blockages deserve investigation sooner rather than later.
Break the Cycle
A drain that keeps blocking is telling you something. Find the cause once, fix it properly, and you stop paying for the same blockage again and again.
We clear blocked drains and find out why they keep blocking. Our engineers carry out CCTV surveys with footage and a written report, then carry out drain repairs, from relining to excavation, across Dorset, Hampshire, Wiltshire, Bristol and Somerset, including Poole and Bournemouth.
Find the cause once and the call-outs stop. Ring 0800 001 6568 to book a survey, or request a free quote online and we’ll come back to you with a fixed price.